Filter
Top Products
234 Ethernet port management using the CLI
Table 91
shutdown port command parameters and variables
Parameters and
variables
Description
line <portlist>
Specifies the port numbers to shut down or disable.
Enter the port numbers you want to disable.
ATTENTION
If you omit this parameter, the system uses the port
number you specified in the interface command.
The shutdown [line <portlist>] command is executed in the
Interface Configuration command mode.
Figure 87 "shutdown port command output" (page 234) displays sample
output from the shutdown [line <portlist>] command.
ATTENTION
You can disable switch ports that are trunk members, if you choose to disable
them one by one. If you choose to disable all ports of the unit or stack, the
changes can have effect on the ports belonging to MLTs.
Figure 87
shutdown port command output
no shutdown command
The no shutdown command enables the port. The syntax for the no
shutdown command is:
no shutdown [line <portlist>]
The no shutdown command is executed in the Interface Configuration
command mode.
Table 92 "no shutdown command parameters and variables" (page
235) describes the parameters and variables for the no shutdown command.
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.