Filter
Top Products
176 Power over Ethernet for the Ethernet Routing Switch 2526T-PWR and 2550T-PWR
—End—
PoE tab items
Table 46 "PoE tab items" (page 176) describes the PoE tab items.
Table 46
PoE tab items
Item Description
AdminEnable Lets you enable or disable PoE on this port.
By default, PoE is enabled.
Detection Status
Displays the operational status of the power-device
detecting mode on the specified port:
• disabled—detecting function disabled
• searching—detecting function is enabled and the
system is searching for a valid powered device on
this port
• deliveringPower—detection found a valid powered
device and the port is delivering power
• fault—power-specific fault detected on port
• test—detecting device in test mode
• otherFault
ATTENTION
Nortel recommends against using the test
operational status.
PowerClassifications Classification is a way to tag different terminals on
the Power over LAN network according to their power
consumption. Devices such as IP telephones, WLAN
access points, and others can be classified according to
their power requirements.
PowerPriority Lets you set the power priority for the specified port to:
•
critical
•
high
• low
Nortel Ethernet Routing Switch 2500 Series
Overview — System Configuration
NN47215-500 (323162-B) 02.02 Standard
4.1 19 November 2007
Copyright © 2007, Nortel Networks
.