Filter
Top Products
E6581528
E-26
5
5.15 Changing the display unit % to A (ampere)/V (volt)
: Current/voltage unit selection
Example of setting
During the operation of the VFAS1-6022PL (rated current 4.0A) at the rated load (100% load), units are displayed
as follows:
1) Display in percentage terms 2) Display in amperes/volts
Output current:
4.0A
DC voltage:575
V
(Converted into AC
voltage)
DC voltage:100%
Output current:
100%
＊
＊
if
was set in
if was set in
[Parameter setting]
Title Function Adjustment range Default setting
Current/voltage unit selection
: %
: % → A (ampere)/V (volt)
• Function
These parameters are used to change the unit of monitor display.
% ⇔A (ampere)/V (volt)
Current 100% = Inverter’s rated current
Voltage 100% = 500Vac ( if is set in)
575Vac ( Default setting or if is set in)
690Vac ( if is set in)
* The converts the following parameter settings:
• A display Current monitor display
Setting of electronic thermal protection level 1/2/3/4 , , , ,
DC braking current
Stall prevention level
• V display Voltage monitor display
V/f 5-point setting , , , ,
Note: Base frequency voltage 1~4 (, , , ) is always displayed in the unit of V.