Agilent Technologies 34970A Switch User Manual


 
String Parameters String parameters can contain virtually any set of
ASCII characters. A string must begin and end with matching quotes;
either with a single quote or with a double quote. You can include the
quote delimiter as part of the string by typing it twice without any
characters in between. The following command uses a string parameter:
DISPlay:TEXT <
quoted_string>
Channel List Parameters Channel list parameters specify one or
more channel numbers on the module in the specified slot. The channel
list must be preceded with the “
@ ” symbol and enclosed in parentheses.
The following command uses a channel list parameter:
ROUTe:CHANnel:DELay? (
@<ch_list>)
The following command configures a scan list to include only
channel 10 on the module in slot 300.
ROUT:SCAN (
@310)
The following command configures a scan list to include multiple
channels on the module in slot 200. The scan list now contains only
channels 10, 12, and 15 (the scan list is redefined each time you send
a new ROUTe:SCAN command).
ROUT:SCAN (
@210,212,215)
The following command configures a scan list to include a range of
channels. When you specify a range of channels, the range may
contain invalid channels (they are ignored), but the first and last
channel in the range must be valid. The scan list now contains
channels 5 through 10 (slot 100) and channel 15 (slot 200).
ROUT:SCAN (
@105:110,215)
5
Chapter 5 Remote Interface Reference
An Introduction to the SCPI Language
301