Filter
Top Products
110
Dell™ Printer Configuration Web Tool
IPsec
Purpose:
To specify the Security Architecture settings for Internet Protocol (IPsec) for encrypted communication to the
printer.
Va l ues :
NOTE:
If IPsec is enabled with incorrect settings, you must disable it using the IPsec menu on the operator panel.
Certificate Management*
1
Click to display the Certificate Management page and to manage a security certification from the
page.
Category Displays the device to certificate.
Issued To Displays the device to certificate.
Issuer Displays the issuer to certificate.
Serial Number Displays the serial number of the device.
Public Key Method Displays the public key method.
Public Key Size Displays the size of public key.
Valid From Displays the time the certificate is valid.
Valid Until Displays the time the certificate is invalid.
Status Displays whether certificate is valid or not.
Certificate Purpose Displays the purpose of certificate.
Certificate Selection Status Displays the type of device certificate.
Delete Click to delete this certificate.
Delete All Certificates*
1
Click to delete all the certificates.
*1
This item is available only when the self-signed certificate has been generated.
*2
This item is effective only when connected via SSL/TLS (https). Only the administrator is allowed to display the pages.
IPsec Settings Protocol Select the check box to enable the protocol.
IKE Authentication Method Displays the type of authentication method used for IPsec.
Pre-Shared Key Sets a shared key. Up to 255 alphanumeric characters, periods, and
hyphens can be used.
Re-enter Pre-Shared Key Enters the shared key again to confirm it.
IKE SA Lifetime Sets the lifetime for IKE SA from 5 to 28,800 minutes.
IPsec SA Lifetime Sets the lifetime for IPsec SA from 5 to 2,880 minutes.
DH Group Sets the DH group.
PFS Select the check box to enable the PFS setting.
Remote peers IPv4 address Sets the IP address to connect to.
Remote peers IPv6 address Sets the IP address to connect to.
Non IPsec communication
policy
Allows communication with a device which does not support IPsec.