Intel SBCEGBESW1 Switch User Manual


 
Ethernet Configuration Commands
84 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
Example
The following example configures the duplex operation of Ethernet port 1 to full duplex
operation.
negotiation
The negotiation Interface Configuration (Ethernet, port-channel) mode command enables
auto-negotiation operation for the speed and duplex parameters of a given interface. To
disable auto-negotiation, use the
no form of this command.
Syntax
negotiation [capability1 [capability2…capability5]]
no negotiation
Parameters
capability — Specifies the capabilities to advertise. (Possible values: 10h, 10f,
100h,100f, 1000f)
Default Configuration
Auto-negotiation is enabled.
If unspecified, the default setting is to enable all capabilities of the port.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
If capabilities were specified when auto-negotiation was previously entered, not
specifying capabilities when currently entering auto-negotiation overrides the previous
configuration and enables all capabilities.
Console(config)#
interface ethernet ext.
1
Console(config-if)#
duplex full