Filter
Top Products
IP Address Commands
122 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
Example
The following example configures VLAN 1 with IP address 131.108.1.27 and subnet
mask 255.255.255.0
ip address dhcp
The ip address dhcp Interface Configuration (Ethernet, VLAN, port-channel) mode
command acquires an IP address for an Ethernet interface from the Dynamic Host
Configuration Protocol (DHCP) server. To deconfigure an acquired IP address, use the
no
form of this command.
Syntax
ip address dhcp [hostname host-name]
no ip address dhcp
Parameters
• host-name — Specifies the name of the host to be placed in the DHCP option 12 field.
This name does not have to be the same as the host name specified in the
hostname
Global Configuration mode command. (Range: 1-20 characters)
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet, VLAN, port-channel) mode
User Guidelines
This command is only functional if the device is in Switch mode.
The
ip address dhcp command allows any interface to dynamically learn its IP address
by using the DHCP protocol.
Some DHCP servers require that the DHCPDISCOVER message have a specific host
name. The
ip address dhcp hostname host-name command is most typically used when
the host name is provided by the system administrator.
Console(config)# interface vlan 1
Console(config-if)# ip address 131.108.1.27 255.255.255.0