Intel SBCEGBESW1 Switch User Manual


 
SNMP Commands
246 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
snmp-server host
The snmp-server host Global Configuration mode command specifies the recipient of
Simple Network Management Protocol Version 1 or Version 2 notifications. To remove
the specified host, use the
no form of this command.
Syntax
snmp-server host {ip-address | hostname} community-string [traps | informs] [1 | 2]
[
udp-port port] [filter filtername] [timeout seconds] [retries retries]
no snmp-server host {ip-address | hostname} [traps | informs]
Parameters
ip-address — Specifies the IP address of the host (targeted recipient).
hostname — Specifies the name of the host. (Range:1-158 characters)
community-string — Specifies a password-like community string sent with the
notification operation.
(Range: 1-20)
traps — Indicates that SNMP traps are sent to this host. If unspecified, SNMPv2 traps
are sent to the host.
informs — Indicates that SNMP informs are sent to this host. Not applicable to
SNMPv1.
1 — Indicates that SNMPv1 traps will be used.
2 — Indicates that SNMPv2 traps will be used. If
port—Specifies the UDP port of the host to use. If unspecified, the default UDP port
number is 162.
(Range:1-65535)
filtername — Specifies a string that defines the filter for this host. If unspecified,
nothing is filtered.
(Range: 1-30 characters)
seconds — Specifies the number of seconds to wait for an acknowledgment before
resending informs. If unspecified, the default timeout period is 15 seconds. (Range: 1-
300)
retries — Specifies the maximum number of times to resend an inform request. If
unspecified, the default maximum number of retries is 3. (Range: 0-255)
Default Configuration
This command has no default configuration.