Intel SBCEGBESW1 Switch User Manual


 
802.1x Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 399
Default Configuration
Access is enabled.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
An access port cannot be a member in an unauthenticated VLAN.
The native VLAN of a trunk port cannot be an unauthenticated VLAN.
For a general port, the PVID can be an unauthenticated VLAN (although only tagged
packets would be accepted in the unauthorized state.)
Example
The following example enables access to the VLAN to unauthorized devices.
dot1x multiple-hosts
The dot1x multiple-hosts Interface Configuration mode command enables multiple hosts
(clients) on an 802.1x-authorized port, where the authorization state of the port is set to
auto. To return to the default configuration, use the no form of this command.
Syntax
dot1x multiple-hosts
no dot1x multiple-hosts
Default Configuration
Multiple hosts are disabled.
Command Mode
Interface Configuration (Ethernet) mode
Console(config-if)# dot1x auth-not-req