Intel SBCEGBESW1 Switch User Manual


 
System Management Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 323
Syntax
traceroute {ip-address |hostname}[size packet_size] [ttl max-ttl] [count packet_count]
[
timeout time_out] [source ip-address] [tos tos]
Parameters
ip-address — IP address of the destination host.
hostname — Host name of the destination host. (Range: 1-158 characters)
packet_size — Number of bytes in a packet. (Range: 40-1500)
max-ttl — The largest TTL value that can be used. The traceroute command
terminates when the destination is reached or when this value is reached. (Range:1-
255)
packet_count — The number of probes to be sent at each TTL level. (Range:1-10)
time_out — The number of seconds to wait for a response to a probe packet.
(Range:1-60)
ip-address — One of the device’s interface addresses to use as a source address for the
probes. The device normally selects what it feels is the best source address to use.
tos — The Type-Of-Service byte in the IP Header of the packet. (Range: 0-255)
Default Configuration
The default number of bytes in a packet is 40.
The default maximum TTL value is 30.
The default number of probes to be sent at each TTL level is 3.
The default timeout interval in seconds is 3.
Command Mode
User EXEC mode
User Guidelines
The traceroute command takesadvantage of the error messages generated by the devices
when a datagram exceeds its time-to-live (TTL) value.
The
traceroute command starts by sending probe datagrams with a TTL value of one.
This causes the first device to discard the probe datagram and send back an error message.
The
traceroute command sends several probes at each TTL level and displays the round-
trip time for each.