Intel SBCEGBESW1 Switch User Manual


 
ACL Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 45
deny-tcp
deny-udp
Parameters
disable-port — Specifies that the port is disabled.
source — Specifies the IP address or host name from which the packet was sent.
Specify
any to indicate IP address 0.0.0.0 and mask 255.255.255.255.
source-wildcard — (Optional for the first type) Specifies wildcard bits by placing 1s
in bit positions to be ignored. Specify
any to indicate IP address 0.0.0.0 and mask
255.255.255.255.
destination — Specifies the IP address or host name to which the packet is being sent.
Specify
any to indicate IP address 0.0.0.0 and mask 255.255.255.255.
destination-wildcard — (Optional for the first type) Specifies wildcard bits by placing
1s in bit positions to be ignored. Specify
any to indicate IP address 0.0.0.0 and mask
255.255.255.255.
protocol — Specifies the abbreviated name or number of an IP protocol. The
following table lists protocols that can be specified:
IP Protocol Abbreviated Name Protocol Number
Internet Control Message Protocol icmp 1
Internet Group Management Protocol igmp 2
IP in IP (encapsulation) Protocol ip 4
Transmission Control Protocol tcp 6
Exterior Gateway Protocol egp 8
Interior Gateway Protocol igp 9
User Datagram Protocol udp 17
Host Monitoring Protocol hmp 20
Reliable Data Protocol rdp 27
Inter-Domain Policy Routing Protocol idpr 35
Ipv6 protocol ipv6 41
Routing Header for IPv6 ipv6-route 43
Fragment Header for IPv6 ipv6-frag 44
Inter-Domain Routing Protocol idrp 45
Reservation Protocol rsvp 46
General Routing Encapsulation gre 47
Encapsulating Security Payload (50) esp 50
Authentication Header ah 51
ICMP for IPv6 ipv6-icmp 58
EIGRP routing protocol eigrp 88
Open Shortest Path Protocol ospf 89