Intel SBCEGBESW1 Switch User Manual


 
Ethernet Configuration Commands
86 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
mdix
The mdix Interface Configuration (Ethernet) mode command enables cable crossover on
a given interface. To disable cable crossover, use the
no form of this command.
Syntax
mdix {on | auto}
no mdix
Parameters
on — Manual mdix is enabled.
auto — Automatic mdi/mdix is enabled.
Default Configuration
The default setting is on.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Auto: All possibilities to connect a PC with cross or normal cables are supported and are
automatically detected.
On: It is possible to connect to a PC only with a normal cable and to connect to another
device only with a cross cable.
No: It is possible to connect to a PC only with a cross cable and to connect to another
device only with a normal cable.
Example
In the following example, automatic crossover is enabled on port 1.
Console(config)#
interface ethernet ext.
1
Console(config-if)#
mdix
auto