Intel SBCEGBESW1 Switch User Manual


 
Address Table Commands
24 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
Example
The following example registers the MAC address:
The following example registers the MAC address and adds ports statically.
bridge multicast forbidden address
The bridge multicast forbidden address Interface Configuration (VLAN) mode command
forbids adding a specific multicast address to specific ports. Use the no form of this
command to restore the default configuration.
Syntax
bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} {add |
remove} {ethernet interface-list | port-channel port-channel-number-list}
no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address}
Parameters
add — Adds ports to the group.
remove — Removes ports from the group.
mac-multicast-address — A valid MAC multicast address.
ip- multicast-address — A valid IP multicast address.
interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces;
hyphen is used to designate a range of ports.
port-channel-number-list — Separate nonconsecutive valid port-channels with a
comma and no spaces; a hyphen is used to designate a range of port-channels.
Default Configuration
No forbidden addresses are defined.
Console(config)#
interface vlan
8
Console(config-if)#
bridge multicast address
01:00:5e:02:02:03
Console(config)#
interface vlan
8
Console(config-if)#
bridge multicast address
01:00:5e:02:02:03
add ethernet
ext.1, ext.2