Filter
Top Products
QoS Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 171
• match-any — Checks that the packet matches one or more classification criteria in
the class map match statement.
Default Configuration
By default, the match-all parameter is selected.
Command Mode
Global Configuration mode
User Guidelines
The class-map Global Configuration mode command is used to define packet
classification, marking and aggregate policing as part of a globally named service policy
applied on a per-interface basis.
The Class-Map Configuration mode enables entering up to two
match Class-map
Configuration mode commands to configure the classification criteria for the specified
class. If two
match Class-map Configuration mode commands are entered, each should
point to a different type of ACL (e.g., one to an IP ACL and one to a MAC ACL). Since
packet classification is based on the order of the classification criteria, the order in which
the
match Class-Map Configuration mode commands are entered is important.
If there is more than one match statement in a
match-all class map and the same
classification field appears in the participating ACLs, an error message is generated.
Note: A class map in match-all mode cannot be configured if it contains both an IP ACL and a
MAC ACL with an ether type that is not 0x0800.
Example
The following example creates a class map called class1 and configures it to check that
packets match all classification criteria in the class map match statement.
show class-map
The show class-map User EXEC mode command displays all class maps.
Syntax
show class-map [class-map-name]
Console(config)# class-map class1 match-all
Console(config-cmap)#