Intel SBCEGBESW1 Switch User Manual


 
Using CLI
4 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
MAC Access-List — Configures conditions required to allow traffic based on MAC
addresses. The mac access-list Global Configuration mode command is used to enter
the MAC access-list configuration mode.
Starting the CLI
The device can be managed over a direct connection via a Telnet connection. The device
is managed by entering command keywords and parameters at the prompt. Using the
device command-line interface (CLI) is very similar to entering commands on a UNIX
system.
If access is via a Telnet connection, ensure that the device has a defined IP address,
corresponding management access is granted, and the workstation used to access the
device is connected to the device prior to using CLI commands.
1. Enter the following commands to begin the configuration procedure:
2. Configure the device and enter the necessary commands to complete the required
tasks.
3. When finished, exit the session with the exit command.
When a different user is required to log onto the system, use the login Privileged EXEC
mode command. This effectively logs off the current user and logs on the new user.
Editing Features
Entering Commands
A CLI command is a series of keywords and arguments. Keywords identify a command,
and arguments specify configuration parameters. For example, in the command show
interfaces status ethernet Ext.1, show, interfaces and status are keywords, ethernet is an
argument that specifies the interface type, and Ext.1 specifies the port.
To enter commands that require parameters, enter the required parameters after the
command keyword. For example, to set a password for the administrator, enter:
When working with the CLI, the command options are not displayed. The command is not
selected from a menu, but is manually entered. To see what commands are available in
each mode or within an Interface Configuration, the CLI does provide a method of
displaying the available commands, the command syntax requirements and in some
instances parameters required to complete the command. The standard command to
request help is ?.
Console> enable
Console# configure
Console(config)#
Console(config)# username admin password alansmith