Filter
Top Products
10. RECALL FROM MEMORY KEY: This key is used
to recall an existing procedure from memory. You
can recall and use any of the previously created
welding procedures that are stored in one of the
eight memory locations. Simply press the
RECALL FROM MEMORY key and then the
appropriate MEMORY LOCATION NUMBER key.
If you press the RECALL FROM MEMORY key and
then change your mind, you can exit this function
by pressing the DISPLAY RECALL key. If the
memory location you select does not contain a
stored welding procedure, this will be indicated in
the display window. Select another memory loca-
tion. It is not necessary to save a procedure back
to memory after it is recalled from memory. When
a procedure is saved into a memory location, it
can be recalled from there until another procedure
is stored in that location or the location is cleared.
The RECALL FROM MEMORY and SAVE TO
MEMORY keys can be used to clear a memory
location.
Press the SAVE TO MEMORY key and then
the RECALL FROM MEMORY key . (Do not
press both keys at the same time.) A message in
the display window will ask you to press the MEM-
ORY LOCATION NUMBER key of the memory
location you want to clear.
If you press the SAVE TO MEMORY and RECALL
FROM MEMORY keys and then change your
mind, you can exit this function by pressing the
DISPLAY RECALL key.
11. HIGH TEMPERATURE LIGHT: The high tempera-
ture light comes on when the internal machine
temperature exceeds the allowed limit. Output is
disabled until the machine cools down and the
high temperature light goes out.
OPERATION
B-10 B-10
POWER WAVE 450
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC
RECALL
SAVE
RECALL