Filter
Top Products
C-5 C-5
ACCESSORIES
g. Install new pump and v-band clamp:
• Do not apply any lubricant to pump’s
drive coupling.
• Pump body is properly oriented with its
strainer at the 6:00 position.
• Tighten v-clamp with 15 to 30 in-lbs. of
torque.
h. Attach coolant lines to QD and reser-
voir.
i. Wipe dry all areas wetted by coolant.
Dispose of towels in an environmentally
responsible manner (see Recommended
Coolants).
j. Reinstall cooler into machine.
4. Motor removal or replacement:
• Do not reuse the 4 internal-tooth star
washers. Replace with new parts.
5. Installing the fan:
• Slide onto motor shaft until the fan is
located between 0.25 to 0.50 inches
from the heat exchanger.
• Tighten set screw with 65 to 75 in-lbs
of torque against motor shaft’s flat.
• Fan rotation is counterclockwise, as
viewed from fan-end of motor’s shaft.
• Fan pulls air through the heat
exchanger, blows it over the motor,
then exhausts it through the reservoir.
POWER WAVE 450
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC