Filter
Top Products
Chapter 9: Link Aggregation Control Protocol (LACP)
122
5. Enter an aggregator ID number in the Aggregator ID field. The
number must be the base port number (or lowest port number) of an
aggregator. For instance, an aggregator of ports 12,16 and 17 is
assigned the ID number 12.
6. Select the Load Balance Method. Choose from the following:
Src MAC— Specifies source MAC address as the load distribution
method.
Dst MAC— Specifies destination MAC address as the load
distribution method.
Src-Dst MAC— Specifies source address and destination MAC
address as the load distribution method.
Src IP— Specifies source IP address as the load distribution
method.
Dst IP— Specifies destination IP address as the load distribution
method.
Src-Dst IP— Specifies source address and destination IP address
as the load distribution method.
7. Click a port number to add to the aggregator. A green check mark
indicates a port has been selected. You can select multiple ports.
To deselect a port, click the box that indicates the port number.
8. Click Add.
A confirmation message is displayed.
9. Click SAVE
to save your changes to the startup configuration file.