Filter
Top Products
Chapter 26: sFlow
346
Specifying an sFlow Collector
Use this procedure to specify the IP address and the UDP port of an sFlow
collector on your network. The packet sampling data and the packet
counters are sent by the switch to the collector specified. You can specify
only one collector.
To select the Collector tab from the sFlow page, do the following:
1. Select the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 144 on
page 344.
2. From the Discovery & Monitoring tab, select sFlow.
The sFlow page is displayed with the Port Configurations tab selected.
See Figure 145 on page 344.
3. From the sFlow page, select the Collector tab.
The sFlow page is displayed with the Collector Tab selected. See
Figure 147.
Figure 147. sFlow Page with Collectors Tab
4. Click Add
.
The sFlow Collector page is displayed. See Figure 148 on page 347.