Filter
Top Products
AlliedWare Plus Version 2.2.4 Management Software Web Browser User’s Guide
283
Enabling RIP on a VLAN Interface
To enable RIP and connect remote networks dynamically, you must
enable RIP on VLAN interfaces. When RIP is enabled on a VLAN
interface, the VLAN interface sends and receives RIP packets, and the
network where the VLAN belongs is advertised through RIP.
To enable RIP on a VLAN interface, you must add the VLAN to the RIP
routing process by performing the following procedure:
1. Select the Layer 3 tab.
The Layer 3 tab is displayed. See Figure 115.
Figure 115. Layer 3 Tab
2. From the Layer 3 tab, select or move the cursor over RIP and select
Add RIP Interface.
The RIP Interface page is displayed. See Figure 116 on page 284.