Filter
Top Products
AlliedWare Plus Version 2.2.4 Management Software Web Browser User’s Guide
33
When the Switch
Does Not Display
the Login Page
When the switch does not display the Web interface even though you
enter the IP address of the switch on the Web browser, you must enable
HTTP or HTTPS service on the switch through the CLI by performing the
following steps:
1. “Logging on to the CLI through the Console Port” on page 33.
Or
Log on to the CLI using the Telnet or SSH protocol.
Note
To start a Telnet or SSH management session, see AlliedWare Plus
Management Software Version 2.2.4 Command Line Interface
User’s Guide.
2. “Checking the Status of HTTP and HTTPS Services in the CLI” on
page 34.
3. “Enabling HTTP or HTTPS Service in the CLI” on page 35.
4. “Saving your Changes in the CLI” on page 36.
Logging on to the
CLI through the
Console Port
To log on to the CLI through the console port on the switch, perform the
following procedure:
1. Connect the RJ-45 connector on the management cable to the console
port on the switch.
2. Connect the other end of the cable to an RS-232 port on a terminal or
a PC with a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
4. Press Enter.
You are prompted for a user name and password.
5. Enter a user name and password. If this is the initial management
session of the switch, enter “manager” as the user name and “friend”
as the password. The user name and password are case sensitive.