Filter
Top Products
Chapter 3: Basic Switch Parameters
64
Displaying System Information
To view basic information about the switch, select the System Tab.
The Dashboard Page is displayed as shown in Figure 3 on page 28.
The following fields are displayed:
Up Time— Indicates the length of time since the switch was last
reset or power cycled in days, hours, minutes and seconds.
The System section displays the following information:
MAC Address— Indicates the MAC address of the switch.
Contact— Displays the contact person for the switch. To specify
this field, see “Setting the Switch Information” on page 48.
Serial No.— Displays the unique serial number of the switch.
Location— Displays the location of the switch. To specify this
field, see “Setting the Switch Information” on page 48.
System Name— Indicates the name of the switch. To specify this
field, see “Setting the Switch Information” on page 48.
Version— Lists the software version number of the AlliedWare
Plus software.
The Services section displays the following information:
IPv6 Management— Indicates if IPv6 Management is enabled or
disabled on the switch.
Spanning Tree— Indicates if RSTP or STP is enabled on the
switch. The default setting is RSTP.
802.1x Port Authentication— Indicates if 802.1x Port
Authentication is enabled or disabled on the switch.
SNMP— Indicates the SNMP setting of the switch.
QoS— Indicates is QoS is enabled or disabled on the switch.
RIP— Indicates the HTTP setting of the switch
HTTP— Indicates the HTTP setting of the switch
LLDP— Indicates if LLDP is enabled or disabled on the switch.
Telnet— Indicates if Telnet is enabled or disabled on the switch.
SFLOW— Indicates is sFlow is enabled or disabled on the switch.
SSH— Indicates if SSH is enabled or disabled on the switch.
IGMP Snooping— Indicates if IGMP Snooping is enabled or
disabled on the switch.