Filter
Top Products
Chapter 3: Basic Switch Parameters
46
3. Specify the following fields as necessary:
Telnet— Check the checkbox to enable the Telnet server on the
switch. To disable the server on the switch, uncheck the checkbox.
SSH— Check the checkbox to enable the SSH server on the
switch. To disable the server on the switch, uncheck the checkbox.
Note
Both the Remote Log and Server IP Address fields are used only to
set a remote log server. For information on these fields, see
“Configuring a Remote Log Server” on page 47.
Remote Log— Check the checkbox to enable the switch to send
status and error messages to a remote log server. To disable the
switch to sent messages to a remote log server, uncheck the
checkbox.
Server IP Address— Enter the IPv4 address of the remote log
server if you check the Remote Log checkbox above. Enter the IP
address in the IPv4 format: nnn.nnn.nnn.nnn.
4. Click Apply.
5. Click SAVE
to save your changes to the startup configuration file.