Filter
Top Products
Chapter 9: Link Aggregation Control Protocol (LACP)
124
5. Select the Load Balance Method. Choose from the following:
Src MAC— Specifies source MAC address as the load distribution
method.
Dst MAC— Specifies destination MAC address.
Src-Dst MAC— Specifies source address/destination MAC
address.
Src IP— Specifies source IP address.
Dst IP— Specifies destination IP address.
Src-Dst IP— Specifies source address/destination IP address.
6. Add or remove the member ports of the aggregator by clicking on the
ports.
A check mark indicates the port has been selected.
Note
You cannot add ports that have lower port number than the base
port number (lowest port number) of an aggregator. Also, you are
not allowed to remove the port with the lowest port number of an
aggregator. Because the aggregator ID number is the base port
number of an aggregator, adding or removing the port with the
lowest port number causes a conflict with the aggregator ID number.
7. Click Apply.
A confirmation message is displayed.
8. Click SAVE
to save your changes to the startup configuration file.