Filter
Top Products
259
Chapter 21
Setting Static Routes
To make remote networks communicate, you must add static routes or
dynamic routes, or both to the routing table. Static routes are configured
manually to add routing information to the routing table. This chapter
provides information about static routes.
The procedures in this chapter describe how to display a list of static
routes on the switch, and how to add and delete a static route. See the
following sections:
“Displaying Static Routes” on page 260
“Adding a Static Route” on page 262
“Deleting a Static Route” on page 264
“Displaying the Routing Table” on page 265
For more information about static routes, see the following chapters in the
AlliedWare Plus Management Software Version 2.2.4 Command Line
Interface User’s Guide:
Internet Protocol Version 4 Packet Routing
IPv4 Routing Commands