Filter
Top Products
3-25
Cisco MGX 8950 Hardware Installation Guide
Release 3, Part Number 78-14147-02 Rev. A0, November 2002
Chapter 3 Installing a Cisco MGX 8950
Installation Procedures
Figure 3-12 Connecting the Back Card to the APS Connector
Step 2 Carefully install the back card into the APS connector by pushing firmly, with a straight motion, until
the back card is securely connected
Caution A rocking motion during connector mating can bend or damage the APS connector pins.
Step 3 Repeat Step 1 and Step 2 to install a second back card on the APS connector. Figure 3-13 shows two
back cards installed in the APS connector.
Top view
APS
connector
Back card
Alignment
slot
Card extractors
shown in "in" position
44143
Guide tabsGuide tabs