Filter
Top Products
3-47
Cisco MGX 8950 Hardware Installation Guide
Release 3, Part Number 78-14147-02 Rev. A0, November 2002
Chapter 3 Installing a Cisco MGX 8950
Installation Procedures
Complete the following steps to connect an international AC power cable to the switch:
Step 1 Insert the female connector into the AC tray receptacle, as shown in Figure 3-30.
Figure 3-30 AC Power Tray Cable (International)
Step 2 Twist the plug clockwise to secure.
Step 3 Loosen the nut on the black strain relief clamp and then slide the metal housing over the plug.
Step 4 Insert the metal tabs (located on both sides of the housing) into the slots found on either side of housing
into receptacle and then push down on the housing to secure it.
Step 5 Tighten the thumbscrew at the top of the housing by hand.
Step 6 Tighten the nut on the strain relief to secure the cable to the housing.
Step 7 Insert the other end of the cable into the wall outlet.
Step 8 If you are using a secondary (redundant) power supply, repeat Step 1 through Step 7 for the other
AC power cable.
AC
IN
AC
IN
D
C O
UT
48455
To outlet
Slots
Captive
screw
Strain-relief nut
Tabs