Filter
Top Products
3-45
Cisco MGX 8950 Hardware Installation Guide
Release 3, Part Number 78-14147-02 Rev. A0, November 2002
Chapter 3 Installing a Cisco MGX 8950
Installation Procedures
The CP connection can also be set up through a terminal server, as shown in Figure 3-27.
Figure 3-27 Terminal Server Connection to the Console Port
For further information about server management and configuration set up, refer to the appropriate
software configuration guide for your switch and your release.
Connect Power to the Cisco MGX 8950 Switch
The section provides the following installation procedures to connect the power:
• Connect AC Power to the Switch, page 3-46
• Connect DC Power to the Switch, page 3-49
Warning
Never install an AC power module and a DC power module in the same chassis.
Ta b l e 3-4 Terminal Settings
Setting Value
Baud rate 9600 bps
Character size 8 data bits
Parity None
Stop bits 1
Hardware flow control None
PXM
UI-S3
C
P
M
P
A
L
1
N
L
2
N
A
L
A
A
R
M
E
X
T
C
L
K
1
E
X
T
C
L
K
2
44371
PXM-UI-S3
back card
Workstation
Terminal server
Serial cable
Serial, LAN,
or dial-up
connection