Filter
Top Products
CHAPTER
2-1
Cisco MGX 8950 Hardware Installation Guide
Release 3, Part Number 78-14147-02 Rev. A0, November 2002
2
Preparing for Installation
This chapter lists the requirements for the installation of the Cisco MGX 8950 switch and its related
components. It includes the following sections:
• Safety Requirements, page 2-1
• Site Requirements, page 2-10
• Required Tools and Equipment, page 2-21
• Unpacking the Box, page 2-22
• Verifying Contents, page 2-23
• Inspecting for Damage, page 2-23
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment.
Warning
This unit is intended for installation in restricted access areas. A restricted access area is where
access can only be gained by service personnel through the use of a special tool, lock and key, or
other means of security, and is controlled by the authority responsible for the location.
Caution Before you start the installation procedures, read the entire chapter for important information and
safety warnings.
Safety Requirements
This section describes safety requirements for the Cisco MGX 8950 switch. Before you install the
Cisco
MGX 8950 switch, ensure that all of the criteria in this section are met. The section describes the
following safety
requirements:
• Safety Guidelines, page 2-2
• Maintaining Safety with Electricity, page 2-6
• Preventing ESD Damage, page 2-7
• General Maintenance Guidelines, page 2-8