Filter
Top Products
5-29
• A SCSI gross error occurs
• An unexpected disconnect occurs
• A SCSI reset occurs
• A parity error is detected
• The handshake-to-handshake timer is expired
• The general purpose timer is expired
To determine exactly which condition(s) caused the
interrupt, read the SCSI Interrupt Status Zero (SIST0)
and SCSI Interrupt Status One (SIST1) registers.
DIP DMA Interrupt Pending 0
This status bit is set when an interrupt condition is
detected in the DMA portion of the LSI53C810A. The
following conditions cause a DMA interrupt to occur:
• A PCI parity error is detected
• A bus fault is detected
• An abort condition is detected
• A SCRIPTS instruction is executed in single step
mode
• A SCRIPTS interrupt instruction is executed
• An illegal instruction is detected
To determine exactly which condition(s) caused the
interrupt, read the DMA Status (DSTAT) register.
Register: 0x18 (0x98)
Chip Test Zero (CTEST0)
Read/Write
FMT Byte Empty in DMA FIFO [7:0]
This was a general purpose read/write register in
previous LSI53C8XX family chips. Although it is still a
read/write register, LSI Logic reserves the right to use
these bits for future LSI53C8XX family enhancements.
7 0
FMT
11111111