Filter
Top Products
Task Table
Issue 10 June 2005 183
Go to the RFA Website
The Remote Feature Activation (RFA) website automates some of the upgrade procedures,
including generating a License File.
1. At your laptop/PC browser, go to the http://rfa.avaya.com Website:
2. Using your SSO, log in to the RFA website.
3. Follow the links to the RFA Information page.
4. Complete the information necessary to create a License File.
Note:
Note: You must enter a valid hardware serial number before you can actually create a
license file. If you don’t have a valid hardware serial number, you can exit RFA
while you get the number. The record you created remain in the Transaction state
until you create the license file.
If you have problems with a hardware serial number that is not in the SAP
database, go to the If you have problems with RFA
section.
Have direct connection
If you have a direct connection between RFA and the switch:
1. Using your RFA Job Aids, run the Features Extraction Tool (FET) from the RFA website to
create a Switch Configuration File.
2. When prompted, type in the Transaction ID number.
3. The FET creates and uploads the Switch Configuration File automatically.
4. Do not deliver the License File at this time. You will deliver and install it later in this upgrade
procedure.
No direct connection
If you do not have a direct connection between RFA and the switch:
1. Run the Features Extraction Tool (FET) from your laptop/PC to create a Switch
Configuration File.
2. When prompted, type in the Transaction ID number.
3. Use the FET instructions to create a new switch connection profile.
4. Create the Switch Configuration File.
5. Upload the Switch Configuration File to the RFA website.
6. Deliver the License File to your laptop/PC for installation later in this procedure.