Filter
Top Products
Task table
Issue 10 June 2005 223
Installation (no direct connection)
If you do not have a direct connection between RFA and the switch:
1. Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi”
chapter of the RFA Job Aid, deliver the License File to your laptop/PC.
2. Open the License Installation Tool (LIT) application at your laptop/PC.
3. Use the LIT instructions to add a switch connection profile to the tool.
4. Use the LIT instructions to install the License File on the switch.
5. If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
Administer no-license/emergency numbers
To administer no-license/emergency numbers:
1. At the SAT type change system-parameters features and press RETURN.
The Feature-Related System Parameters screen displays.
2. In the Emergency Numbers - Internal field (optional) type a valid extension.
Note:
Note: This number cannot be a hunt group or ACD number.
3. In the Emergency Number - External field (required) type a 21-digit, dialpad-valid
character string that can include trunk access codes. The default for this field is 911.
4. In the No-License Incoming Call Number field (optional) type a valid extension.
Note:
Note: This number cannot be a hunt group or ACD number.
5. Press ENTER to save the changes.
Set daylight savings rules
You can set up to 15 customized daylight savings time rules. If you have switches in several
different time zones, you can set up rules for each. A daylight savings time rule specifies the
exact time when you want to transition to and from daylight savings time and the amount of time
offset at the point of transition.