Filter
Top Products
Add Integrated Announcements/TN2501AP
Issue 10 June 2005 263
Note:
Note: If the TN2501AP or TN750 circuit packs are at the system limit and you insert a
VAL circuit pack, the red LED on that circuit pack stays on, indicating that the
system does not accept it.
3. Connect the Backplane Adapter (Figure 85
) to the Amphenol connector on the back of the
switch cabinet, corresponding to the TN2501AP circuit pack slot.
4. Connect the LAN cable to the RJ-45 connector on the Backplane Adapter.
Administer the IP connections
Use the following commands to administer the IP connections of the announcement circuit
pack.
list configuration board
To ensure that the switch recognizes the TN2501AP circuit pack after it is latched in the carrier
slot.
1. At the SAT, type list configuration board board-location and press RETURN.
The System Configuration report appears.
Figure 86: System Configuration screen (list configuration board)
2. Verify the following field values:
● Board Type shows VAL-ANNOUNCEMENT
● Code is TN2501AP
list configuration board 1c08 SPE A
SYSTEM CONFIGURATION
Board Assigned Ports
Number Board Type Code Vintage u=unassigned t=tti p=psa
01C08 VAL-ANNOUNCEMENT TN2501AP HW00 FW001 01 02 03 04 05 06 07 08
09 10 11 12 13 14 15 16
17 18 19 20 21 22 23 24
25 26 27 28 29 30 31 32
U
Command successfully completed