Filter
Top Products
Upgrading R6csi/R7csi/R8csi to Avaya Communication Manager on an Avaya DEFINITY Server CSI
194 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Installation (direct connection)
If you have a direct connection between the RFA and the switch, do the following:
1. Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi”
chapter of the RFA Job Aid, deliver the License File.
Note:
Note: This procedure sends the License File to the switch and installs it. In order for this
option to work, the INADS connection to the switch must be working.
2. If the system has IP endpoints registered and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
Installation (no direct connection)
If you do not have a direct connection between RFA and the switch, do the following:
1. Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi”
chapter of the RFA Job Aid, deliver the License File to your laptop/PC.
2. Open the License Installation Tool (LIT) application at your laptop/PC.
3. Use the LIT instructions to add a switch connection profile to the tool.
4. Use the LIT instructions to install the License File on the switch.
5. If the system has IP endpoints registered, and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
Display Memory-Configuration
To display the memory-configuration:
1. Log in as craft. If the Translation Corruption Detected message appears, refer to
Translation Corruption Detected
on page 358.
2. Type display memory-configuration and press Enter. Make sure that in the Total DRAM
field the SIMM field in the SPE-A column says 16.