Filter
Top Products
Task table
Issue 10 June 2005 211
Go to the RFA website
The Remote Feature Activation (RFA) website automates some of the upgrade procedures,
including generating a License File.
1. At your laptop/PC browser, go to the http://rfa.avaya.com Website:
2. Using your SSO, log in to the RFA website.
3. Follow the links to the RFA Information page.
4. Complete the information necessary to create a License File.
Note:
Note: You must enter a valid hardware serial number before you can actually create a
license file. If you don’t have a valid hardware serial number, you can exit RFA
while you get the number. The record you created remain in the Transaction state
until you create the license file.
If you have problems with a hardware serial number that is not in the SAP
database, go to the If you have problems with RFA
section.
Have direct connection
Note:
Note: If you are upgrading from Release 10 or higher to Avaya Communication
Manager, omit this section.
If you have a direct connection between RFA and the switch and you are upgrading from
Release 9 to Avaya Communication Manager:
1. Using your RFA Job Aids, run the Features Extraction Tool (FET) from the RFA website to
create a Switch Configuration File.
2. When prompted, type in the Transaction ID number.
3. The FET creates and uploads the Switch Configuration File automatically.
4. Do not deliver the License File at this time. You will deliver and install it later in this upgrade
procedure.
No direct connection
Note:
Note: If you are upgrading from Release 10 or higher to Avaya Communication
Manager, omit this section.