Filter
Top Products
Task Table
Issue 10 June 2005 193
2. Insert the Avaya Communication Manager media (orange card) into the new TN2402
processor circuit pack slot.
Note:
Note: In most cases the orange card will not be on-site and the upgrade performed
using the pre-loaded Avaya Communication Manager on the TN2402 Processor
circuit pack. If this is true, skip to Step 7.
3. Place the TN2402 processor circuit pack into the slot vacated by the TN798 processor.
4. Lock the TN2402 processor into place to power up the cabinet.
The system reads the Avaya Communication Manager automatically.
5. Install the original translation card when the system prompts (beeps)
You have 2 minutes to replace the Avaya Communication Manager card with the translation
card.
6. At the system prompt, log in as craft. Skip to the next section.
7. Insert the original translation card into the TN2402 Processor circuit pack slot and place the
TN2402 into the slot vacated by the TN798 Processor circuit pack.
8. Power up the cabinet.
9. Verify that the upgrade was completed to the expected software load.
If it is not the correct load, then the Avaya Communication Manager media must be on-site
and you must perform Steps 2-6 above.
Install the License File
Pre-installation
To prepare for the license file installation:
1. Type save translation and press Enter.
After the translations have been copied (about 10 minutes), the system returns an error
code, which must be a zero; otherwise, the translations are not copied.
2. Type reset system 3 and press Enter.
Wait until the system has completely reset before continuing.
3. If the system has IP endpoints registered, unplug the Ethernet cable from the TN799
(C-LAN) circuit pack.
This disconnects (unregisters) all IP endpoints.
4. Type set time and press Enter.
Ensure that the system date and time are set correctly.