Filter
Top Products
Install Equipment Room Hardware
Issue 10 June 2005 67
Label the Main Distribution Frame
Figure 23 shows the graphic symbols used on the supplied labels for the system,
cross-connections, information outlets, and cables.
To label the MDF:
1. Write the floor and building identification on each label as required.
2. Insert the labels into the plastic holders.
3. Snap the holders into the appropriate locations on the MDF.
Figure 23: Label Graphic Symbols and Nomenclature
4. Label the cables as required using the supplied labels. Label code number 220A (Comcode
103970000) contains all required labels.
49/34 24
50/25 25
Table 6: Sneak Fuse Connector Pinout (continued)
Connector
Pin Numbers
Pair/Fuse
Number
2 of 2
Figure notes:
1. Floor and building identification
2. Cabinet
3. Carrier
4. Slot
5. Information outlet
6. Site/satellite closet
7. Tie circuit
8. Floor
9. Building
r758422i LJK 050996