Filter
Top Products
Add IP Solutions
Issue 10 June 2005 291
Install the circuit packs
To install the TN799B/C and 2302AP circuit packs:
1. If replacing the TN799 circuit pack, install the TN799B/C circuit pack in the slot vacated by
the TN799 circuit pack.
2. For convenience install the TN2302AP circuit pack in the rightmost slot vacated by the
TN802B and where the adapter is connected to the corresponding backplane connector.
The other 2 slots are now available for other circuit packs.
When you plug in the TN2302AP IP Media Processor, the circuit pack starts to boot. The RED
LED stays on until an IP address is assigned to the circuit pack.
3. Type list configuration all and press Enter to verify that the system recognizes the
TN2302AP circuit packs.
Administration
To administer the TN799B/C and 2302AP circuit packs:
1. Administer the TN799B/C C-LAN, if necessary. Refer to the Administration for Network
Connectivity for Avaya Communication Manager.
2. Administer the IP Media Processor, which is usually done remotely. Call your service
representative to start the process.
3. Complete the administration and testing. Refer to Initial Administration Steps for C-LAN and
IP Media Processor on page 284 and Test the External Connection to the LAN on
page 286.