Filter
Top Products
Adding or Removing Hardware
338 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
2. Be aware that there are installations that use repeatered metallic lines between the MUX
and the “dumb” block. These lines require DC power for the repeaters and this DC power is
present at the “dumb” block interface to the CPE equipment. A loopback jack is required in
this configuration to properly isolate and terminate the DC power.
To check for the presence of DC, make the following 4 measurements at the network interface
jack:
3. From transmit tip (T, Pin 5) to receive tip (T1, Pin 2)
4. From transmit ring (R, Pin 4) to receive ring (R1, Pin 1)
5. From transmit tip (T, Pin 5) to transmit ring (R, Pin 4)
6. From receive tip (T1, Pin 2) to receive ring (R1, Pin 1)
All measurements should read 0 (zero) volts DC. For pin numbers and pin designations, refer to
Integrated Channel Service Unit (ICSU) Installation and Operation.
.Install ISDN converters and adapters
This section provides information on ISDN converters and adapters that are sometimes
necessary when connecting to coaxial facilities in either a multicarrier cabinet or a single carrier
cabinet.
Connections include:
● Integrated Services Data Network Primary Rate Interface (ISDN-PRI) to Direct Access
Secondary Storage (DASS)
● PRI to Digital Private Network Signaling System (DPNSS)
● PRI to ISDN Basic Rate Interface (ISDN-BRI)
Converter circuit packs known as common channel signaling converter (CCSC), types 1 and 2.