Filter
Top Products
Upgrading R9csi/R10csi/Communication Manager 1.x/2.x to Avaya Communication Manager 2.2 on an
222 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
Install the License File
Pre-installation
To prepare for the license file installation:
1. Type save translation and press Enter.
After the translations have been copied (about 10 minutes), the system returns an error
code, which must be a zero; otherwise, the translations are not copied.
2. Type reset system 3 and press Enter.
Wait until the system has completely reset before continuing.
3. If the system has IP endpoints registered, unplug the Ethernet cable from the TN799
(C-LAN) circuit pack.
This disconnects (unregisters) all IP endpoints.
4. Type set time and press Enter.
Ensure that the system date and time are set correctly.
Installation (direct connection)
If you have a direct connection between the RFA and the switch:
1. Go to the RFA website, and, following the instructions in the “Deliver to G3r/G3si/G3csi”
chapter of the RFA Job Aid, deliver the License File.
Note:
Note: This procedure sends the License File to the switch and installs it. In order for this
option to work, the INADS connection to the switch must be working.
2. If the system has IP endpoints registered and you unplugged the Ethernet cable from the
TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.