Filter
Top Products
Add IP Solutions
Issue 10 June 2005 281
Figure 91: TN2302AP Amphenol Adapter
Installing the TN2302AP IP Media Processor
To install a TN2302AP IP Media Processor, you must install
● One or more TN2302AP circuit pack(s).
● One or more TN799DP circuit pack(s) (a TN799DP can support more than one
TN2302AP).
● An IP Media Processor adapter.
Connect the cables for TN799DP
To connect the cables for TN799DP:
1. Determine into which port slots you are putting the TN799DP C-LAN circuit packs.
From the rear of the cabinet:
2. Connect a 259A connector to the backplane connector corresponding to each TN799DP
slot.
3. Connect one end of each DW8 cable to each 259A connector.
Figure notes:
1. Amphenol connector to backplane
connector corresponding to TN2302AP
slot
2. To Ethernet
3. 9-pin connector for maintenance
addfipm2 KLC 083000
1
2
3