Filter
Top Products
Adding or Removing Hardware
286 Installation, Upgrades and Additions for Avaya CMC1 Media Gateways
- Set the Net Region field to 1 unless you are given a different number.
- Set the Enable Eth Pt field to y
7. Press Enter to save the information and effect the new settings.
Refer to the Administration for Network Connectivity for Avaya Communication Manager for
more information on these administration steps and for the steps to administer IP Softphones
and H.323 trunks.
Note:
Note: The administration of the TN2302AP is the same as that for the TN802B.
Test the External Connection to the LAN
To test the external IP connections, ping the C-LAN or IP Media Processor server and ping a
known computer connected to your network. If everything is configured correctly, the Result
column on the Ping Results screen reads pass. If it reads abort, verify the IP-address
information and check the connectivity, including the cabling.
To test the external connection to the TN799DP and 2302AP circuit packs:
1. Type ping ip-address nnn.nnn.nnn.nnn board UUCSS and press Enter. The variable
nnn.nnn.nnn.nnn is the IP address of the TN2302AP IP Media Processor and UUCSS is
the cabinet, carrier, and slot of the TN2302AP IP Media Processor.
2. Type ping ip-address nnn.nnn.nnn.nnn board UUCSS and press Enter. The variable
nnn.nnn.nnn.nnn is the IP address of the customer’s gateway and UUCSS is the cabinet,
carrier, and slot of the TN2302AP IP Media Processor.
3. Type ping ip-address nnn.nnn.nnn.nnn board UUCSS and press Enter. The variable
nnn.nnn.nnn.nnn is the IP address of another computer beyond the gateway and UUCSS
is the cabinet, carrier, and slot of the TN2302AP IP Media Processor.
The TN2302AP IP Media Processor is now installed in the carrier and connected to the IP
network.
ping ip-address 192.168.10.21
PING RESULTS
End-pt IP Port Port Type Result Time(ms) Error Code
192.168.10.21 01A13 MEDPRO PASS 10 1124