Filter
Top Products
3-96 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
3.4 Port Configuration
This section includes configuration menus for the down-link ports, up-link ports,
and management port. Most of these menus apply to all port types. However, the
management port only supports a few basic menus, and Packet Filtering (page 3-
134) is only provided for the management port.
Note – The port designations used in the following menus include NETP0 to NETP7
for
up-link ports, SNP0 to SNP15 for down-link ports, and NETMGT for the
management port.
3.4.1 Displaying Connection Status
You can use the port Status page to display the current connection status, including
link state, speed/duplex mode, flow control, auto-negotiation, and broadcast storm
control.
When viewing the status of port connections through the web interface or CLI, the
following parameters are displayed:
■ Port Type – The port type (1000BASE-SX, 1000BASE-T or 10/100BASE-TX).
■ Port – The port or aggregated link. (Up-link ports NETP0 to NETP7, down-link
ports SNP0 to SNP15, or the management port NETMGT.)
■ Description – The interface label.
■ Admin Status – The configured state of the interface:
■ Web - Either Enabled or Disabled.
■ CLI - (Port Admin) Either up or down.
■ Link Status – The state of the connection. Either Up or Down.
■ Port Operation Status
18
– The state of the connection. Either Up or Down.
(Displayed only when the link is up.)
■ Speed/Duplex – Shows the current speed and duplex mode.
■ Flow Control – The configured state of flow control:
■ Web - Either IEEE 802.3x, Back-Pressure or None.
■ CLI - Either Enabled or Disabled. Flow Type shows IEEE 802.3x, Back-Pressure
or None.
18.CLIonly.