Filter
Top Products
Chapter 3 General Management of the Switch 3-97
■ Auto-negotiation – The configured state of auto-negotiation. Either enabled or
disabled.
■ Protect Status – The configured state of broadcast storm control on the interface.
To set the threshold value, see “Broadcast Storm Control (Global Setting)” on
page 3-67.
■ MAC Address
19
– The physical layer address of the port.
■ Port Capabilities
20
– The capabilities that are advertised for a port during auto-
negotiation. The following capabilities are supported:
■ 10half – 10 Mbit/sec half-duplex operation
■ 10full – 10 Mbit/sec full-duplex operation
■ 100half – 100 Mbit/sec half-duplex operation
■ 100full – 100 Mbit/sec full-duplex operation
■ 1000full – 1000 Mbit/sec full-duplex operation
■ Sym – The transmitting and receiving of pause frames for flow control
■ FC – Flow control
■ LACP Status
21
– The configured state of Link Aggregation Control Protocol
(LACP) on the port.
Web Interface: Displaying Connection Status for the Ports
To display port status information and configure connections for one or more
interfaces:
1. Open Up Links / Down Links / Management Port
⇒ Status.
2. Select the check box next to the interface to configure.
3. Click Configure.
See “Configuring Interface Connections” on page 3-102.
19.CLIonly. TodisplaythisparameterthroughtheWebinterface,see“SettingtheIPAddress”onpage 3-12.
20.CLIonly. TodisplaythisparameterthroughtheWebinterface,see“ConfiguringInterface Connections”on
page 3-102.
21.CLIonly.