Chapter 3 General Management of the Switch 3-135
■ Source – The frame’s TCP/UDP source address, netmask, and port range
(between 0 and 65,535).
■ Destination – The frame’s TCP/UDP destination address, netmask, and port
range (between 0 and 65,535).
■ Fragment – The rule will only match packets with the More Fragments (MF) bit
set or with a fragment offset greater than zero. If fragment is not set, the rule will
match both fragments and non-fragmented packets.
■ Log – Logs any matching packets in the log buffer. The maximum number of
entries stored in the log buffer is 64. When the buffer fills, it will wrap around and
overwrite the oldest entries. Note that the log is stored in RAM and is lost when
the switch is reset.
3.4.7.1 Web Interface: Filtering Traffic to the Management Port
1. Open Management Port ⇒ Packet Filtering.
2. Specify the required rules.
3. Click Add.
The rule in the following example permits TCP traffic from source address 10.7.1.1 to
destination address 10.8.1.1, using TCP ports 10 to 30.
FIGURE 3-43 The Management Ports ⇒ Packet Filtering Window