Filter
Top Products
4-124 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
Syntax
switchport mode {trunk | hybrid}
no switchport mode
■ trunk – Specifies a port as an end-point for a VLAN trunk. A trunk is a direct
link between two switches, so the port transmits tagged frames that identify
the source VLAN. However, note that frames belonging to the port’s default
VLAN (associated with the PVID) are sent untagged.
■ hybrid – Specifies a hybrid VLAN interface. The port may transmit tagged or
untagged frames.
Default Setting
All ports are in hybrid mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
The following shows how to set the configuration mode to port SNP1, and then
set the switchport mode to hybrid:
4.3.12.5 switchport acceptable-frame-types
Use this command to configure the acceptable frame types for a port. Use the no
form to restore the default.
Syntax
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
■ all – The port accepts all frames, tagged or untagged.
■ tagged – The port only receives tagged frames.
Console(config)#interface ethernet SNP1
Console(config-if)#switchport mode hybrid
Console(config-if)#