Sunfire B1600 Switch User Manual


 
Chapter 4 Command-Line Reference 4-115
Related Commands
spanning-tree cost (4-112)
4.3.11.11 spanning-tree edge-port
Use this command to specify an interface as an edge port. Use the no form to restore
the default.
Syntax
spanning-tree edge-port
no spanning-tree edge-port
Default Setting
NETP0-7, NETMGT: Disabled
SNP0-15: Enabled (fixed at this setting)
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
You can enable this option if an interface is attached to a LAN segment that is at
the end of bridged LAN or to an end node. Since end nodes cannot cause
forwarding loops, they can pass directly through to the spanning tree forwarding
state. Specifying Edge Ports provides quicker convergence for devices such as
workstations or servers, retains the current forwarding database to reduce the
amount of frame flooding required to rebuild address tables during
reconfiguration events, does not cause the spanning tree to initiate
reconfiguration when the interface changes state, and also overcomes other STA-
related timeout problems. However, remember that Edge Port should only be
enabled for ports connected to an end-node device.