Filter
Top Products
B-4 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
B.4 Using System Logs
If a fault does occur, refer to the other manuals for the system chassis to ensure that
the problem you encountered is actually caused by the switch. If the problem
appears to be caused by the switch, follow these steps:
1. Enable logging.
2. Set the error messages reported to include all categories.
3. Designate the SNMP host that is to receive the error messages.
4. Repeat the sequence of commands or other actions that lead up to the error.
5. Make a list of the commands or circumstances that led to the fault. Also make a
list of any error messages displayed.
6. Contact customer service.
Example
B.4.1 Log Messages
Log messages generated by this switch are listed in the following table:
Console(config)#logging on
Console(config)#logging history flash 7
Console(config)#snmp-server host 10.1.0.23
.
.
.
TABLE B-1 Log Messages
Message Description Level
3
System coldStart notification Switch cold boot 5
System warmStart notification Switch warm boot 5
Unit 1 Port YY
1
link-up notification Port link up 6
Unit 1 Port YY link-down notification Port link down 6
Trunk 1 link-up notification Aggregated link up 6