Chapter 4 Command-Line Reference 4-127
Command Usage
■ If an interface is not a member of VLAN 1 and you assign its PVID to this
VLAN, the interface will automatically be added to VLAN 1 as an untagged
member. For all other VLANs, an interface must first be configured as an
untagged member before you can assign its PVID to that group.
■ If acceptable frame types is set to all or switchport mode is set to hybrid, the
PVID will be inserted into all untagged frames entering the ingress port.
Example
The following example shows how to set the PVID for port SNP1 to VLAN 3:
4.3.12.8 switchport allowed vlan
Use this command to configure VLAN groups on the selected interface. Use the no
form to restore the default.
Syntax
switchport allowed vlan {add vlan [tagged | untagged]|remove vlan}
no switchport allowed vlan
■ add vlan – VLAN identifier to add.
■ remove vlan – VLAN identifier to remove.
Do not enter leading zeros. (Range: 1-4094)
Note – You cannot use the no switchport allowed vlan command on the
NETMGT port. (If you do, the switch will display an error message.)
Console(config)#interface ethernet SNP1
Console(config-if)#switchport native vlan 3
Console(config-if)#