Filter
Top Products
4-168 Sun Fire B1600 Blade System Chassis Switch Administration Guide • June 2003
Syntax
channel-group channel-id
no channel-group
channel-id – The port-channel index (Range: 1-6)
Default Setting
The current port will be added to this aggregated link.
Command Mode
Interface Configuration (Ethernet)
Command Usage
■ When configuring static aggregated links, you can only link switches of the
same type.
■ Use no channel-group to remove a port group from an aggregated link.
■ Use no interfaces port-channel to remove an aggregated link from the
switch.
Example
The following example creates aggregated link 1 and then adds port NETP2:
4.3.17.2 lacp
Use this command to enable 802.3ad Link Aggregation Control Protocol (LACP) for
the current interface. Use the no form to disable it.
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet NETP2
Console(config-if)#channel-group 1
Console(config-if)#